65 + 35 Dooble Layer Insulating and Sheathing Extruder Production Line
Wire Core Diameter:0.5-10mm
Out Diamter:1.0-12mm
Production speed:max 350m/min
Capacity:350KG/H:350KG,/H
Payment: T/T or L/C
Production Time: 90 days
65 + 35 Dooble Layer Insulating and Sheathing Extruder Production Line
Application
It's used for the copper wire insulation coating, then the wire get cooling through water to finished products. The product can be power cable, automotive wire, communication cable, magnetic wire, LAN cable and so on.
Main brands for our machine
Motor: SIEMENS,
Inverter: YASKAWA, INOVANCE, SIEMENS,
PLC: Siemens
Touch Screen: Siemens
Low-voltage electrical components: Schneider
Bearings: NSK or SKF
65 Extrusion Host
Applicable Material: PVCE, Plasticization degree of 100%.
Maximum Extrusion Capacity: 350kg/hr.
Finished wire diameter: 1—12mm
Mechanical Center Height: 1000mm
Ratio of Length and Diameter: 1:25
Compression Ratio: 1:2.8
Material of Screw: One Ø90mm, Rotation Rate of Screw: 0—70RPM,
screw with whole tooth nitrogen treatment of alloy steel and chrome-plated polished surface
Material of Screw Cylinder: 38CrMoA1A alloy steel, nitrogen treatment and precisely grinding. The surface hardness inside the screw cylinder is R2-3 degree higher than that of the front surface of the screw and the screw thread.
Gearbox: Imitation of Italian-type, hardened helical gear gearbox, material of cast steel, oil-bath lubrication, tooth-face high-efficiency quenching and adoption of Japanese NACHI bearing.
Electric Heating: total 380V, with even three-phase separated flow.
Screw cylinder electric heating zone 4, the cast aluminum heating ring heating is affixed with cooling air duct.
Head electric heating zone 1, heating by cast aluminum heating ring.
Machine neck electric heating zone 1, electric plate heating
Eye die electric heating zone 1, heating by the electro-thermal tablets.
Cooling: Screw cylinder zone 4, use 4 sets of cooling fans(250W).
Control of Temperature: Use the PID automatic temperature control gauge made in Yangming, Taiwan, automatically set the control under 0-399℃ and use KTYP as the thermal-couple.
Machine head clamping: Using a ratchet quick wrench, chain drive double clamp.
Host Motor: 50HP. Jiangmen motor SINEE invertor
Head clamping: using a ratchet quick wrench, chain driven double clamping.
Main Components:
Φ500—Φ630mm Power Single Head Pay-off Stand
Copper Wire Straightening Machine
Cable Powder Coater
Φ65mm Extruder
Φ35mm Auxiliary Extruder
50KG Auto Granule Sucker + Dryer
Control Panel (PLC Control)
1.5m Pre-Water Cooling Trough
Diameter Inspector
High-Speed Printing Machine
8m Single Layer Main Cooling Trough
Dual Wheel Capstan
12m Horizontal Type Cable Accumulator
15KV Spark Tester
Electronic Sensor Metering Device
Dual-Reel Take-up