Tubular Type Stranding Machine is mainly used to strand not only copper/aluminum conductor for the electric wire and cable but also the cable core, steel core, and steel rope.
4.2.4 the setting out of the I-shaped wheel in the cradle adopts the "hysteresis" tension device, and the tension value adopts the digital display. The tension is adjusted by the stop knob in the cradle, and the tension range is 2kg ~ 20kg. It is installed on the manual operation surface, which is convenient for micro adjustment and is not easy to fail. At the same time, the start stop switch is set, and the original value is memorized after the power is cut off and restarted (that is, the tension is adjusted after the power is cut off, and the original value is memorized after the power is turned on again).
4.2.5 the whole steel casting part of the pay off frame has high precision, high mechanical strength and durability.
4.2.6 the double protection function of "ring touch type" broken wire parking is respectively added at the outlet end of the main engine and under the side of the cylinder, which is convenient for the automatic parking after the line is broken and finished. It is easy to operate and compensate the core in time.
4.2.7 The cylinder adopts 2 + 2 + 2 three section and whole pipe bearing structure. The support frame at the pay off inlet end is supported by double row roller self-aligning bearing, and a set of thrust bearing is added to ensure the bearing capacity of axial movement of the cylinder. The middle and outlet end are supported by three groups of large bearings with flange butt joint and bearing core to connect the pipe body, which is convenient for maintenance and disassembly. The large bearing adopts cylindrical roller shaft Bearing (less rolling element)
4.2.8 new type of oil air lubrication; separate oil pump motor centralized oil supply, with cooling system, thin oil lubrication, labyrinth seal, with dual functions of lubrication and cooling, independent oil tank, underground installation, small floor area, clean working condition.
4.2.9 double automatic shutdown protection function of "high temperature early warning and flow early warning" is added to the large bearing group to avoid damaging other hardware in bad state operation and get timely maintenance.
4.2.10 the cylinder is made of thick wall steel pipe, the internal stress is eliminated before processing, and the dynamic balance is corrected after processing
4.2.11 main engine braking: two groups, two brake calipers in each group, butterfly pneumatic braking device.
4.2.12 the main machine adopts the external wiring mode, lengthening and thickening cylinder, Ø 20mm through hole, Ø 20mm core wire through hole, and equipped with multiple alloy nozzles or guide wheels, so as to make the wiring more smooth, without bending, scratching and job hopping.